If a fuse(s) fail, in general the result is that the green on/switch will illuminate as before, but the display will not illuminate. This is usually caused by the fuses located on the left hand side of the heat press within black fuse holders. See below.
The fuses can be purchased online or over the phone.
To order them online, please see the link here. To order by phone, please call 01332 85 50 85 and quote part code XPFUSE125
If the fuses are working then the problem may be with the internal wiring, or something more such a problem with the electronic boards within the machine.
For a reasonable DIY savvy person it is possible to remove the top cover and review the internal wiring for any possible problems. The below video (and playlist) below goes through this procedure:
The most common problem (after the fuses) is either a loose wire a failed fuse holder. Both of which can be purchased through as a pack from the link below:
https://www.xpres.co.uk/fuse-holders-4-wires-for-beta-presses
If this doesn't solve the issue, please let us know and we can investigate further causes.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article